Suresign 6 Day Early Pregnancy Test - Twin Pack

 
One-step test for the qualitative detection of human chorionic gonadotropin (hCG) in urine to aid in the early detection of pregnancy.
£6.95
Quantity
How to Order?
1. Select Condition
2. Fill out the consultation form
3. Select Product and Checkout
Read more
 
  • No Test works earlier
  • Results in 3 minutes
  • Test 6 days early
  • One-Step test

Suresign pregnancy tests detect elevated levels of HCG, the pregnancy hormone in urine. 


HCG occurs naturally in the body but increases greatly if an egg is fertilised resulting in pregnancy.  

These tests can be taken as early as the first day of a missed period due to their high sensitivity. 

 These pregnancy tests are very easy to use, are over 99% accurate and produce fast results.

If you do have a positive result, we would recommend contacting your doctor for further advice and treatment. 

How to use

How to Use
1. Remove the Pregnancy Test from the foil pouch and use within 1 hour. Hold the test by the thumb grip and remove the cap but do not discard it. 

Either:
Urinate into a clean, dry glass container, then, holding the test upright; dip only the absorbent tip into the urine for at least 10 seconds. 
Note: Do not allow urine to come into contact with the result window. 

OR:
Hold the test by the thumb grip with the exposed absorbent tip pointing downwards directly into your urine stream for at least 10 seconds until thoroughly wet. 
Note: Do not allow urine to come into contact with the result window. 

2. After removing the test your urine, immediately replace the cap over the absorbent tip, lay the test on a flat surface with the test and control window facing upwards, and then begin timing. 

Note: As the test begins to work, you will see the formation of a reddish-purple line in the Control region (C), this indicates the test is working properly. 

3. Some positive results may be observed after 1 minute depending on the concentration of hCG but ideally leave for up to 3 minutes for a line to appear in the Test (T) region. 

Important: 
Read results within 10 minutes. Discard the stick after this time. After 10 minutes you should disregard any change in the result or any lines that appear after this time. 

4. If no coloured line appears in the Control region (C) within 5-10 minutes, the test has not worked properly and should be repeated.